@Trent Teter i was unable to fit a 5mm spacer on my p2's, they're at 130mm width though so maybe it's different for other axles?
@Trent Teter i was unable to fit a 5mm spacer on my p2's, they're at 130mm width though so maybe it's different for other axles?
Does anyone know of an aera hanger and truck chart? I have no clue what sizes are for most aeras
@Terence Liu p2 not spacable
I've played with the chubby and fat cone vibe on aeras and other precisions with rake. I always land back on barrels. When you do I recommend 95 hardcore bs (adds more stability with the hard core insert than canons and is the same size) with 93 .65 seismic in the back, and 88a hardcore with 87 seismic 6.0 in the front. The idea is to have more support on the lean for fast Freeride with the hardcore inserts, then the bushings are super fluid and great for remaining nimble on harder duros.
s
@Trent Teter i got +14 axles and rolling tree chopped 5mm off each so they are +9-+14 making the p2s 134-144
@Sk8bored so your p2s with technically "9mm" axles? And they are a complete hanger at 134 after that?
@Terence Liu I'm running medium defcon bushings in my p2s, they feel better then a .6 bushing+washer. But I really like them feels like I get more lean and less snap out of slides compared to venom
@Francisco Bocanegra Hardcore bushings have just a squish more height, which after putting on the proper pre-load, will have the hanger at the correct height and angle into the pivot cup. We're talking a millimeter and a bit. With Venoms you'll end up being a bit under-angle with correct pre-load.
@Trent Teter you cannot space the axles on Aera Trucks more than a few millimeters. It has been my experience that, much like adjustable angle baseplates, you will find your width or angle and tend to stick to it. Admittedly the axle +__MM system is flawed, and was an imperfect solution to over a decade of slightly different axles and hangers, but the widths are all there if you look at the website assemblies. https://www.skateone.com/aera-skateboard-truck-assembly-k3-k4-custom-set-of-2
@Trent Teter yeah. 134-144