@Sk8bored so your p2s with technically "9mm" axles? And they are a complete hanger at 134 after that?
Does anyone know of an aera hanger and truck chart? I have no clue what sizes are for most aeras
@bhr happy thunder and gecko were two fire decks I was looking at
@Sk8bored can you space your wheels on p2 axles? And what axle size do you have? It's so hard to find specs on aeras you'd think they'd include them in the website they sell them
Wassssup, okay so I had an idea for a thread. Drop below in the comments decks that fit the description of this thread. I'm currently riding a landyachtz Charlie horse and am absolutely obsessed wi...
@Matt Needs Wheels 100% it's essentially a rail grab position for a toe side predict and then I just use my core more and transfer my hand over to the inside pavement. You can even grab inside rail...
Cringiest skate memory was probably going to my local to show my new at the time, girlfriend what downhill was like, wobbled off a pothole and got absolutely smoked right infront of her and a line ...
@Matt Needs Wheels I love doing two hand Tony's, can't relate
@Gabriel Fockler same here, got them for my k5 and haven't really felt the need to find something new since. Really enjoying skating it
@Wil White in theory yes you would compress them equally, but over my experience riding I find that the boardside often takes the load. Choosing a good boardside helps you define your center ...
Blood Orange Drifts; hands down my go to wheel for freeride. 81a and 78a cause flavors are sweet. 81a for all round freeride, 78a if you want to go a bit faster or stop a little harder Bangers wo...
Probably my go to wheel currently, I'm not a huge Powell person like the meta. I've found these wheels to essentially be the new era Morgan. More in the pace feel than the competitors, still l...
@Zach Maxon real. Learn the basics and learn them right that way you progress into a butterfly and not feel cornered into a style of skating or limited by your abilities
This is the deck I was thinking of chopping into skinny cruiser, aka poor man's comet cruiser 9.5 x 40" | Wheelbase 26.5"
I want to start a thread here with intent on sharing your different slower speed cruiser/ side walk slasher set ups, comet cruisers and like welcome too. this is my bonzing diet fatty that I'v...
If you're here reading this you're more than likely familiar with pats risers, but if you are not you should be! They provide some rad gear from a plethora of risers, wedges and foot stops, but my ...
I wish I knew that skating as a whole is so fluid, it is very abstract and on a spectrum of style to effort and enjoyment. Everyone experiences this differently, I think I just wanted to learn abou...
@Sk8bored @Gabriel Fockler so far the set up is incredibly fun for my stand up style, really the only reason I did this set up was for standup and some faster skating. I changed the set up a b...
@Sk8bored sounds solid honestly I might have to try that, I was recommended this set up and told that at 50 gets spicy 😂 so greatly noted. currently thinking of going 84/87 canon front ...
For k5, Has anyone gone with krank 84/84 front 87/87 rear chubby bs canon/barrel rs? I was recommended this by a few people. I've been pretty happy with just hpf barrels, and some aps canons but ap...
I'd like to get see what the opinions of comparison's between standard HPF & APS I've gone back and forth on different shapes and compounds, but overall I feel like I enjoy my standard yellow ...
@Teplitzskate the event is a non sanctioned but protected event. Meaning cars spot the upper and lower and communicate effectively but the road is technically open. It is a small forest service roa...
Free ride event in Eugene Oregon! July 20-21st check out @ridethegem on Instagram!
